Introducción

A few steps to remove the back of the phone.

  1. Turn the phone on its back.
    • Turn the phone on its back.

    Agregar Comentario

  2. Orient the phone as shown.
    • Orient the phone as shown.

    • Remove the battery cover by pushing upward with your thumb.

    Agregar Comentario

    • Place your fingernail at the top of the battery and pry the battery out towards you.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Orient the phone as shown with the battery already removed.

    Agregar Comentario

    • Remove the 2 plastic plugs located on the side and upper quadrant of the rear body panel by using the push-pin and lifting outwards.

    • Use a Phillips #00 screwdriver to remove the 5 screws as shown here.

    Agregar Comentario

    • Place an iPod opener tool in the seam above the antenna.

    • Run the tool around the perimeter of the entire phone.

    Agregar Comentario

    • Check to see that your device looks like the attached photo.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

Cal Poly, Team 4-13, Forte Winter 2010 Miembro de Cal Poly, Team 4-13, Forte Winter 2010

CPSU-FORTE-W10S4G13

5 Miembros

15 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 1

Todo El Tiempo: 3,097