A guide to removing and reinstalling the flip phone's camera.

Turn the phone on its back.
  • Turn the phone on its back.

Agregar Comentario

Orient the phone as shown.
  • Orient the phone as shown.

  • Remove the battery cover by pushing upward with your thumb.

Agregar Comentario

  • Place your fingernail at the top of the battery and pry the battery out towards you.

Agregar Comentario

  • Flip the phone open.

  • Remove the four rubber plugs, located at the corners of the LCD screen, with a push-pin.

  • Use a Phillips #00 screwdriver to remove the four screws located underneath the rubber plugs.

Agregar Comentario

  • Insert the plastic opening tool in the seam of the top portion of the flip phone.

  • Gently pry the seam open.

  • Move the opening tool around the perimeter of the seam and gently take the front LCD face plate out.

Agregar Comentario

  • Close the flip phone.

  • Hold the base of the phone and gently remove the faceplate.

  • Place the phone and the faceplate on a clean, flat surface.

Agregar Comentario

  • Locate the phone camera.

  • Locate the white rubber stopper to left of the camera.

  • Remove white rubber stopper by grabbing an edge with your fingers and gently pulling it off.

Agregar Comentario

  • Lift the copper ribbon cable up from the bottom right hand corner.

Agregar Comentario

  • While holding the copper connection out of the way, use your fingernail to pry the camera out of its socket.

Agregar Comentario


To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.


Cal Poly, Team 4-13, Forte Winter 2010 Miembro de Cal Poly, Team 4-13, Forte Winter 2010


5 Miembros

15 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 2

Todo El Tiempo: 2,062