Introducción

Replacing the ribbon cable.

  1. Turn the closed phone so that the back panel is facing you.
    • Turn the closed phone so that the back panel is facing you.

    • Press down and forward firmly on the gray tab in the middle of the phone.

    Agregar Comentario

  2. Now just lift up on the battery and remove it from the phone.
    • Now just lift up on the battery and remove it from the phone.

    Agregar Comentario

    • Remove the rubber grommet using a Spudger.

    Agregar Comentario

    • Be sure not to lose the screws. They are small!

    • Remove the five screws using a Phillips #00 Screwdriver.

    Agregar Comentario

    • When removing back cover, be careful not to break the speaker wires.

    • Using an iPod Opening Tool, carefully pry off the back cover.

    • Using Tweezers, gently pull speaker wires out.

    Agregar Comentario

    • Separate the two halves.

    Agregar Comentario

    • Carefully pry and lift up on the logic board using an iPod Opening Tool.

    Agregar Comentario

    • Carefully flip the logic board up and out of the way.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Use an iPod Opening Tool to lift up on the keypad and pull it out.

    Agregar Comentario

    • DO NOT TOUCH SOLDERING IRON. IT IS EXTREMELY HOT.

    • De-solder solder joint on front using Soldering Iron.

    Agregar Comentario

    • De-solder solder joint on the back using Soldering Iron.

    Agregar Comentario

    • Carefully detach ribbon cable and remove logic board.

    Agregar Comentario

    • Remove 4 rubber grommets using the Spudger.

    Agregar Comentario

    • Remove 4 screws using the Phillips #00 Screwdriver.

    Agregar Comentario

    • Carefully pry off outer cover using iPod Opening Tool.

    Agregar Comentario

    • Remove speaker using the Spudger.

    Agregar Comentario

    • Remove vibrator using the Spudger.

    Agregar Comentario

    • Lift up LCD display using iPod Opening Tool.

    Agregar Comentario

    • DO NOT TOUCH THE SOLDERING IRON. IT IS EXTREMELY HOT!

    • De-solder solder joint using Soldering Iron.

    Agregar Comentario

    • Pry off ribbon cable using iPod Opening Tool.

    Agregar Comentario

    • Turn phone so that the back side is facing you.

    • Press blue button and remove top half using Spudger.

    Agregar Comentario

    • Remove cable from bottom section.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

David Foster

Miembro Desde 11/04/10

1 Reputación

8 Guías creadas

Equipo

Cal Poly, Team 25-88, Amido Spring 2010 Miembro de Cal Poly, Team 25-88, Amido Spring 2010

CPSU-AMIDO-S10S25G88

4 Miembros

18 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 3,118