Introducción

Buttons bit the dust? Resurrect them with a new keypad by following this simple repair guide:

  1. Turn off the cellphone by pressing down on the red "END" button for 3 seconds. Flip cellphone over and press up on the gray sliding mechanism towards the top of the phone. At the same time, pull on the large silver battery and it should come right off.
    • Turn off the cellphone by pressing down on the red "END" button for 3 seconds.

    • Flip cellphone over and press up on the gray sliding mechanism towards the top of the phone. At the same time, pull on the large silver battery and it should come right off.

  2. Use a T7 Torx screwdriver to remove the four screws that are located underneath the area where the battery was.
    • Use a T7 Torx screwdriver to remove the four screws that are located underneath the area where the battery was.

  3. ¡Envío gratuito para todos los pedidos de más de USD100.00 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda

    ¿Alguna vez arreglaste algo? Eso es genial.

    Comparte tu historia de reparación con #SoyUnGenio

    Todos somos Genios

    Comparte tu historia de reparación con #SoyUnGenio

  4. Be careful when removing the casing as the spudger can damage the plastic cover of the phone. Use the spudger to carefully pry around the sides of the plastic casing and remove the back side of the phone. Use the spudger to carefully pry around the sides of the plastic casing and remove the back side of the phone.
    • Be careful when removing the casing as the spudger can damage the plastic cover of the phone.

    • Use the spudger to carefully pry around the sides of the plastic casing and remove the back side of the phone.

  5. Use the spudger to remove the back side of the phone. The logic board is still connected to the rest of the phone with a gold strip; be careful when removing the board. Use the spudger to gently push the keypad out from the other side of the phone.
    • Use the spudger to remove the back side of the phone.

    • The logic board is still connected to the rest of the phone with a gold strip; be careful when removing the board.

    • Use the spudger to gently push the keypad out from the other side of the phone.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Tyler

Miembro Desde 09/04/10

1 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 34-58, Forte Spring 2010 Miembro de Cal Poly, Team 34-58, Forte Spring 2010

CPSU-FORTE-S10S34G58

5 Miembros

9 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 2,305