Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

If the buckle or part of the wristband is damaged, it is a good idea to replace the bands on both sides so that they match.

Partes

No se especificaron partes.

  1. Spring bars attach the two halves of the wristband to the watch body. The spring bar has a shoulder on either end.
    • Spring bars attach the two halves of the wristband to the watch body. The spring bar has a shoulder on either end.

    • Be prepared to apply some pressure with your fingers to perform the following action.

    • First, slide the wristband down on the spring bar to expose the shoulder of the spring bar.

    • Grasp the exposed shoulder with the tweezers to perform the next step.

  2. This is a challenging step. Do it carefully to prevent the spring bar from flying out of the wristband. Use the tweezer to depress the spring bar so that it collapses by a few millimeters and pops out of the hole that was holding it in place.
    • This is a challenging step. Do it carefully to prevent the spring bar from flying out of the wristband.

    • Use the tweezer to depress the spring bar so that it collapses by a few millimeters and pops out of the hole that was holding it in place.

    • Now carefully pull the other end of the spring bar to detach the wristband from the watch face.

    • Repeat steps 1 and 2 for the other wristband.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Deja Miller

Miembro Desde 14/10/14

462 Reputación

3 Guías creadas

Equipo

USF Tampa, Team 2-5, Blackwell Fall 2014 Miembro de USF Tampa, Team 2-5, Blackwell Fall 2014

USFT-BLACKWELL-F14S2G5

5 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 686