Saltar al contenido principal

Introducción

This guide will walk you through with replacing the motherboard of you LG G Vista. You will need tweezers, a Phillips screwdriver #000, and a small plastic spudger, or your thumb nail.

Partes

No se especificaron partes.

  1. Make sure the device is powered off.
    • Make sure the device is powered off.

  2. Remove the back cover by gently prying open the case of the device from the charging port.
    • Remove the back cover by gently prying open the case of the device from the charging port.

  3. Lift the battery out of its place by prying up from the small notch at the base of the battery.
    • Lift the battery out of its place by prying up from the small notch at the base of the battery.

  4. Remove the eight 3.0 mm screws using the Phillips #000 screwdriver.
    • Remove the eight 3.0 mm screws using the Phillips #000 screwdriver.

  5. Remove the hard shell covering the motherboard.
    • Remove the hard shell covering the motherboard.

  6. Use a pair of tweezers to lift up the white antenna wire. On the other side of the logic board, do the same for the black antenna wire.
    • Use a pair of tweezers to lift up the white antenna wire. On the other side of the logic board, do the same for the black antenna wire.

  7. Use the tweezers to remove the four connectors as well as the back camera. Be careful not to directly touch the camera lenses.
    • Use the tweezers to remove the four connectors as well as the back camera.

    • Be careful not to directly touch the camera lenses.

  8. Lift up and remove the motherboard from the device.
    • Lift up and remove the motherboard from the device.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 9

Todo El Tiempo: 356