Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the phone off.
-
Flip it over so the front screen is facing down.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Slide the release latch down and toward you while lifting up on the left side of the battery cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the three screw covers on the back of the phone. Using your fingernail (or a spudger, pry off screw covers.
-
Using a Phillips #000 Screwdriver, remove the 1.5mm #000 Phillips screws that were under the screw covers.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the two inner 1.5mm #000 Phillips screws and remove them using a Phillips #000 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a plastic opening tool or your fingernail to pry off the back case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the two 1.5mm #000 Phillips screws on the outside of each hinge.
-
Remove the two 1.5mm #000 Phillips screws with a Phillips #000 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pry off the two screw covers on the inside screen, using a spudger or your fingernail.
-
Remove the two 1.5mm #000 Phillips screws that were under the screw covers using the Phillips #000 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four 1.5mm #000 Phillips screws at each of the corners of the phone, using the Phillips #000 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Peel off the gold tape.
-
Gently pry up the metal frame with your fingers so that the screen can be removed.
-
Cancelar: No complete esta guía.
3 personas más completaron esta guía.