Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Kyocera Hydro Life Rear-Facing Camera Replacement

Qué necesitas

  1. Kyocera Hydro Life Rear-Facing Camera Replacement, Rear-Facing Camera: paso 1, imagen 1 de 1
    • Flip the phone so that the screen is facing down.

    • Gently remove the back cover with the grip at the bottom of the phone.

  2. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 2, imagen 1 de 3 Kyocera Hydro Life Rear-Facing Camera Replacement: paso 2, imagen 2 de 3 Kyocera Hydro Life Rear-Facing Camera Replacement: paso 2, imagen 3 de 3
    • Use the tab marked "PULL" to remove the battery from its enclosure.

  3. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 3, imagen 1 de 2 Kyocera Hydro Life Rear-Facing Camera Replacement: paso 3, imagen 2 de 2
    • Remove the six Phillips #00 screws from the back of the enclosure.

    • Use a plastic opening tool to gently remove the plastic piece surrounding the back of the phone enclosure.

  4. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 4, imagen 1 de 1
    • Remove the white sticker.

  5. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 5, imagen 1 de 2 Kyocera Hydro Life Rear-Facing Camera Replacement: paso 5, imagen 2 de 2
    • Using a pair of pliers, gently pry open the camera ribbon slot.

    • This will not take much pressure to open.

  6. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 6, imagen 1 de 1
    • Gently remove the camera ribbon.

    • Be very careful not to rip the ribbon. Use tweezers if needed.

  7. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 7, imagen 1 de 2 Kyocera Hydro Life Rear-Facing Camera Replacement: paso 7, imagen 2 de 2
    • Using a plastic prying tool, gently loosen all 4 corners of the motherboard.

    • Lift the motherboard away from the phone enclosure.

  8. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 8, imagen 1 de 1
    • Remove the black sticker.

    • Be careful when removing the sticker. The sticker will need to be replaced after replacing the camera.

  9. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 9, imagen 1 de 1
    • Remove the camera from the motherboard.

    • This step requires breaking metal.

    • Only cut along the camera square.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Morgan Marshall

Miembro Desde 09/21/18

277 Reputación

2 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 2

Todo El Tiempo: 194