Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Kyocera Hydro Life Rear-Facing Camera Replacement

Qué necesitas

  1. Kyocera Hydro Life Rear-Facing Camera Replacement, Rear-Facing Camera: paso 1, imagen 1 de 1
    • Remove back cover.

    • The back cover has a gap to grip when removing the cover.

  2. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 2, imagen 1 de 3 Kyocera Hydro Life Rear-Facing Camera Replacement: paso 2, imagen 2 de 3 Kyocera Hydro Life Rear-Facing Camera Replacement: paso 2, imagen 3 de 3
    • Remover battery.

    • Lift the battery from the bottom of the phone to remove.

  3. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 3, imagen 1 de 3 Kyocera Hydro Life Rear-Facing Camera Replacement: paso 3, imagen 2 de 3 Kyocera Hydro Life Rear-Facing Camera Replacement: paso 3, imagen 3 de 3
    • Using the eyeglass screw driver, remove the 6 screws.

    • Use PH00

  4. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 4, imagen 1 de 1
    • Remove the white sticker.

  5. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 5, imagen 1 de 2 Kyocera Hydro Life Rear-Facing Camera Replacement: paso 5, imagen 2 de 2
    • Gently pry open the camera ribbon slot.

    • This won't take too much pressure to open.

  6. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 6, imagen 1 de 1
    • Remove camera ribbon.

    • Be very careful not to rip the ribbon. Use tweezers if needed.

  7. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 7, imagen 1 de 2 Kyocera Hydro Life Rear-Facing Camera Replacement: paso 7, imagen 2 de 2
    • Carefully pry to loosen all 4 corners of the motherboard to remove.

    • Remove all ribbons in order to remove the motherboard.

  8. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 8, imagen 1 de 1
    • Remove the black sticker.

    • Be careful removing, because you will need to place the sticker back on once you have replaced the camera.

  9. Kyocera Hydro Life Rear-Facing Camera Replacement: paso 9, imagen 1 de 1
    • Remove the camera.

    • This step requires breaking metal.

    • Only cut along the camera square.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Morgan Marshall

Miembro Desde 09/21/18

277 Reputación

2 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 194