Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

A step-by-step rear camera replacement guide for the Kyocera Hydro Life smartphone.

  1. Flip the phone so that the screen is facing down.
    • Flip the phone so that the screen is facing down.

    • Gently remove the back cover with the grip at the bottom of the phone.

  2. Use the tab marked "PULL" to remove the battery from its enclosure. Use the tab marked "PULL" to remove the battery from its enclosure. Use the tab marked "PULL" to remove the battery from its enclosure.
    • Use the tab marked "PULL" to remove the battery from its enclosure.

  3. Remove the six Phillips #00 screws from the back of the enclosure. Use a plastic opening tool to gently remove the plastic piece surrounding the back of the phone enclosure.
    • Remove the six Phillips #00 screws from the back of the enclosure.

    • Use a plastic opening tool to gently remove the plastic piece surrounding the back of the phone enclosure.

  4. SALTEA LA ACTUALIZACIÓN

    Ahorra reparando con un kit todo en uno.

    Compra Kits de Reparación

    SALTEA LA ACTUALIZACIÓN

    Ahorra reparando con un kit todo en uno.

    Compra Kits de Reparación
  5. Remove the white sticker.
    • Remove the white sticker.

  6. Using a pair of pliers, gently pry open the camera ribbon slot. This will not take much pressure to open.
    • Using a pair of pliers, gently pry open the camera ribbon slot.

    • This will not take much pressure to open.

  7. Gently remove  the camera ribbon.
    • Gently remove the camera ribbon.

    • Be very careful not to rip the ribbon. Use tweezers if needed.

  8. Using a plastic prying tool, gently loosen all 4 corners of the motherboard. Lift the motherboard away from the phone enclosure.
    • Using a plastic prying tool, gently loosen all 4 corners of the motherboard.

    • Lift the motherboard away from the phone enclosure.

  9. Remove the black sticker.
    • Remove the black sticker.

    • Be careful when removing the sticker. The sticker will need to be replaced after replacing the camera.

  10. Remove the camera from the motherboard.
    • Remove the camera from the motherboard.

    • This step requires breaking metal.

    • Only cut along the camera square.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Morgan Marshall

Miembro Desde 21/09/18

277 Reputación

2 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 1

Todo El Tiempo: 118