Kyocera Hydro Life Charging Port Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

This is a replacement guide for the charging port of the Kyocera Hydro Life. This guide requires specialized soldering knowledge and tools. Please ensure that you have these tools before attempting this guide.

Qué necesitas

Paso 1 Charging Port

Kyocera Hydro Life Charging Port Replacement, Charging Port: paso 1, imagen 1 de 2

Kyocera Hydro Life Charging Port Replacement, Charging Port: paso 1, imagen 2 de 2

Remove the back of the phone.

Traducir

Paso 2

Kyocera Hydro Life Charging Port Replacement: paso 2, imagen 3 de 3

Remove the battery by pulling up on the end and towards yourself.

Traducir

Paso 3

Use a PH0 screwdriver to remove the 6 screws which are holding the panel in the phone.

Traducir

Paso 4

Kyocera Hydro Life Charging Port Replacement: paso 4, imagen 3 de 3

Remove the frame from around the back of the phone.
Then remove the back panel of the phone.
Remove the white sticker from in the middle of the phone.

Traducir

Paso 5

Kyocera Hydro Life Charging Port Replacement: paso 5, imagen 3 de 3

Desolder the 7 pins.
If you have never soldered before, follow this guide.
This type of soldering requires very specialized and expensive equipment. Please be careful if you decide to continue following this guide.

Traducir

Paso 6

Desolder the positive and negative terminals.

Traducir

Paso 7

Peel back the copper plated sticker.
If the copper plated sticker is broken, it must be replaced. If it is not broken during disassembly, it can be reused.

Traducir