Saltar al contenido principal

Introducción

This guide gives instructions on how to replace the combined motherboard and flash component pieces. Care should be taken so as not to damage other portions of the circuit board.

Partes

No se especificaron partes.

  1. Orient the phone so that the screen is face down.
    • Orient the phone so that the screen is face down.

    • Place one or both thumbs near the small arrow at the bottom of the phone and firmly push the cover up.

  2. Pull up on the back cover and lift the top to separate it from the phone.
    • Pull up on the back cover and lift the top to separate it from the phone.

  3. Pull the battery out of the device with a thin object such as your nail or credit card.
    • Pull the battery out of the device with a thin object such as your nail or credit card.

  4. Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now

    Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now
  5. Unscrew four 4.3mm Phillips #000 screws.
    • Unscrew four 4.3mm Phillips #000 screws.

  6. Unscrew 2 Y1000 4.8 mm screws.
    • Unscrew 2 Y1000 4.8 mm screws.

  7. Wedge a plastic opening tool under the black outer casing of the phone. Push the plastic opening tool down and outward while rotating the phone to pry the black outer casing off. Do not apply too much pressure to the outer casing, as it could damage internal components.
    • Wedge a plastic opening tool under the black outer casing of the phone. Push the plastic opening tool down and outward while rotating the phone to pry the black outer casing off.

    • Do not apply too much pressure to the outer casing, as it could damage internal components.

  8. Wedge a plastic opening tool under the motherboard directly above the flash. Additionally, use a plastic opening tool to unhook corner labeled in a red square.
    • Wedge a plastic opening tool under the motherboard directly above the flash. Additionally, use a plastic opening tool to unhook corner labeled in a red square.

  9. Gently pull the motherboard out of its compartment. Gently pull the motherboard out of its compartment.
    • Gently pull the motherboard out of its compartment.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Alex Kinstedt

Miembro Desde 05/11/18

483 Reputación

4 Guías creadas

Equipo

IUPUI, Team S2-G6, Baechle Fall 2018 Miembro de IUPUI, Team S2-G6, Baechle Fall 2018

IUPUI-BAECHLE-F18S2G6

3 Miembros

4 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 2

Todo El Tiempo: 67