Repara tus cosas Comunidad Tienda

Krups F203 Coffee Grinder Trigger Assembly Replacement

Introducción

The trigger assembly that connects the button to the motor can sometimes break. This guide will explain how to replace the trigger assembly.

Qué necesitas

  1. Krups F203 Coffee Grinder Trigger Assembly Replacement, Base Plate: paso 1, imagen 1 de 1

    • In each of the four rectangular slots on the bottom of the device, there is an E-shaped clip.

    Editar

  2. Krups F203 Coffee Grinder Trigger Assembly Replacement: paso 2, imagen 1 de 3 Krups F203 Coffee Grinder Trigger Assembly Replacement: paso 2, imagen 2 de 3 Krups F203 Coffee Grinder Trigger Assembly Replacement: paso 2, imagen 3 de 3

    • Wedge the spudger between the flat side of the E-clip and the outside wall of the slot. Then, loosen up the clip by prying it inward with the spudger.

    • Try not to break these clips as this will cause structural integrity issues upon reassembly

    Editar

  4. Krups F203 Coffee Grinder Trigger Assembly Replacement: paso 3, imagen 1 de 2 Krups F203 Coffee Grinder Trigger Assembly Replacement: paso 3, imagen 2 de 2

    • Work your way around the four clips, loosening each a little at a time. Eventually, all four clips will be loose enough to remove the base plate.

    Editar

  5. Krups F203 Coffee Grinder Trigger Assembly Replacement, Detach Trigger Button from Base Plate: paso 4, imagen 1 de 1

    • The trigger button is held in with light tension clips. Gently pry them back to release.

    Editar

  6. Krups F203 Coffee Grinder Trigger Assembly Replacement: paso 5, imagen 1 de 2 Krups F203 Coffee Grinder Trigger Assembly Replacement: paso 5, imagen 2 de 2

    • Remove the white trigger.

    Editar

  7. Krups F203 Coffee Grinder Trigger Assembly Replacement: paso 6, imagen 1 de 1

    • Desolder the contact points between the trigger button and the red wire and also where the plug attaches to the trigger button

    • Be sure to reference the how to solder video posted to the device page

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Autor

con 3 otros colaboradores

Ian Hancock

Miembro Desde 10/22/14

414 Reputación

3 Guías creadas

Insignias: 13

+ 10 más insignias

Equipo

Baylor, Team 4-2, Williams Fall 2014 Miembro de Baylor, Team 4-2, Williams Fall 2014

BU-WILLIAMS-F14S4G2

3 Miembros

8 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 7

Ultimos 30 días: 32

Todo El Tiempo: 5,346