Saltar al contenido principal

Introducción

Back Cover Teardown guide must be used first to get inside the camera. Later, soldering guides will be used.

Partes

No se especificaron partes.

  1. Remove the two 6.2mm Phillips screws on both sides of camera's back cover. Remove the two 6.2mm Phillips screws on both sides of camera's back cover.
    • Remove the two 6.2mm Phillips screws on both sides of camera's back cover.

  2. Turn camera so the bottom is facing up and the front is facing away.
    • Turn camera so the bottom is facing up and the front is facing away.

    • Remove the two 6.2mm Phillips screws on the bottom back cover of the camera.

    • Back cover is now unscrewed an can be removed.

  3. Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now

    Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now
  4. Have the back of the camera facing up.
    • Have the back of the camera facing up.

    • Unscrew the 6.2mm Phillips screw next to the viewfinder.

    • The back cover is now unscrewed. Lift up and pull the cover off evenly.

  5. The capacitor is located at the bottom center of the camera.
    • The capacitor is located at the bottom center of the camera.

  6. Desolder the two connections at the top of the flash capacitor.
Conclusión

To reassemble your device, follow these instructions in reverse order.

Michelle

Miembro Desde 04/04/11

86 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 25-28, Garner Spring 2011 Miembro de Cal Poly, Team 25-28, Garner Spring 2011

CPSU-GARNER-S11S25G28

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 3

Últimos 30 Días: 10

Todo El Tiempo: 1,851