Introducción

Back Cover Teardown guide must be used first to get inside the camera. Later, soldering guides will be used.

Partes

No se requieren partes.

  1. Remove the two 6.2mm Phillips screws on both sides of camera's back cover.
    • Remove the two 6.2mm Phillips screws on both sides of camera's back cover.

    Agregar Comentario

  2. Turn camera so the bottom is facing up and the front is facing away.
    • Turn camera so the bottom is facing up and the front is facing away.

    • Remove the two 6.2mm Phillips screws on the bottom back cover of the camera.

    • Back cover is now unscrewed an can be removed.

    Agregar Comentario

    • Have the back of the camera facing up.

    • Unscrew the 6.2mm Phillips screw next to the viewfinder.

    • The back cover is now unscrewed. Lift up and pull the cover off evenly.

    Agregar Comentario

    • The capacitor is located at the bottom center of the camera.

    Agregar Comentario

  3. Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Michelle

Miembro Desde 04/04/11

86 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 25-28, Garner Spring 2011 Miembro de Cal Poly, Team 25-28, Garner Spring 2011

CPSU-GARNER-S11S25G28

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 3

Últimos 30 Días: 11

Todo El Tiempo: 1,767