Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Remove damaged case and replace with new casing.

Partes

No se especificaron partes.

  1. Using a Phillips #00 screwdriver, remove two (5.39 mm) screws next to the battery slot. Remove the metal piece holding down the lanyard, then remove the lanyard. Remove the metal piece holding down the lanyard, then remove the lanyard.
    • Using a Phillips #00 screwdriver, remove two (5.39 mm) screws next to the battery slot.

    • Remove the metal piece holding down the lanyard, then remove the lanyard.

  2. Opening a device may void its warranty. Using a Phillips #00 screwdriver, remove seven screws located throughout the camera. One (6.25 mm) screw is located on the top right corner, right to the "OK" button.
    • Opening a device may void its warranty.

    • Using a Phillips #00 screwdriver, remove seven screws located throughout the camera.

    • One (6.25 mm) screw is located on the top right corner, right to the "OK" button.

    • Four (4.45 mm) screws are on the bottom of the camera.

    • Two (2.95 mm) screws are on the left side of the camera, above the USB Port.

  3. Carefully remove the rear camera casing. Carefully remove the front camera casing.
    • Carefully remove the rear camera casing.

    • Carefully remove the front camera casing.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Michael

Miembro Desde 24/06/10

63 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 2-8, Johann Summer 2010 Miembro de Cal Poly, Team 2-8, Johann Summer 2010

CPSU-JOHANN-R10S2G8

5 Miembros

16 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 3

Todo El Tiempo: 1,724