Introducción

Use this guide to remove and replace front and back casing.

Partes

No se requieren partes.

  1. Use your finger tip to slide battery cover door away from the center of the camera.
    • Use your finger tip to slide battery cover door away from the center of the camera.

    • The battery door should spring open.

      • If this does not happen, gently open the door lifting from the outer bottom side of the camera.

    Agregar Comentario

  2. Remove the old batteries.
    • Remove the old batteries.

    Agregar Comentario

    • Remove 7 screws from the outer case with a Phillips #00.

      • All screws are 4.45mm.

      • There are 2 screws on the port side.

      • There are 2 screws on starboard side.

      • There are 3 screws on the bottom.

    Agregar Comentario

    • Make sure the battery cap is "up".

    • Pull the outer case off with your hands.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Taggart Ashby

Miembro Desde 15/04/10

315 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 26-19, Regan Spring 2010 Miembro de Cal Poly, Team 26-19, Regan Spring 2010

CPSU-REGAN-S10S26G19

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 1

Últimos 30 Días: 6

Todo El Tiempo: 2,101