Saltar al contenido principal

KitchenAid Professional 600 Top Cover Replacement

Qué necesitas

  1. KitchenAid Professional 600 Top Cover Replacement, Top Cover: paso 1, imagen 1 de 1
    • Take out the screw which holds on the silver band using a Phillips #2 screwdriver.

    • Remove the silver band.

  2. KitchenAid Professional 600 Top Cover Replacement: paso 2, imagen 1 de 1
    • Remove the four Phillips #2 screws located around the mixer where the band was removed.

    • This picture only shows two of the screw that you need to remove. The other two are on the exact opposite side of the mixer.

  3. KitchenAid Professional 600 Top Cover Replacement: paso 3, imagen 1 de 1
    • Remove the top of the mixer to reveal the inner parts.

    • The top should lift off, but may not if it is stuck. A sharp strike from the back with the hand may unstick it. It will slide forward about a 3/8 of an inch. Push it back again from the front and it should be free enough to lift.

Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Luke

Miembro Desde 04/11/16

1,353 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 25-4, Maness Spring 2016 Miembro de Cal Poly, Team 25-4, Maness Spring 2016

CPSU-MANESS-S16S25G4

4 Miembros

18 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 5

Ultimos 30 días: 35

Todo El Tiempo: 2,443