Saltar al contenido principal

KitchenAid KSM150PSER Circuit Board Replacement

Qué necesitas

  1. KitchenAid KSM150PSER Circuit Board Replacement, Circuit Board: paso 1, imagen 1 de 2 KitchenAid KSM150PSER Circuit Board Replacement, Circuit Board: paso 1, imagen 2 de 2
    • Using a Phillips #2 screwdriver, remove the 10mm screw on the back cover by rotating it counterclockwise.

    • The back cover is now free. Remove it by pulling it back and up.

    • Ensure that the mixer is disconnected from any electrical source prior to removing the back cover.

  2. KitchenAid KSM150PSER Circuit Board Replacement: paso 2, imagen 1 de 2 KitchenAid KSM150PSER Circuit Board Replacement: paso 2, imagen 2 de 2
    • Using a Phillips #1 screwdriver, remove the 9.5mm screw above the circuit board by rotating it counterclockwise.

    • If you can't see the screw, try pulling the seal down past the wires to make the screw more accessible.

  3. KitchenAid KSM150PSER Circuit Board Replacement: paso 3, imagen 1 de 2 KitchenAid KSM150PSER Circuit Board Replacement: paso 3, imagen 2 de 2
    • Using pliers or tweezers, remove the connectors of the four wires attached to the circuit board.

  4. KitchenAid KSM150PSER Circuit Board Replacement: paso 4, imagen 1 de 1
    • Grab the wires and tilt the edge of the board up to lift the circuit board up and out.

Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Luke Leonard

Miembro Desde 01/24/18

562 Reputación

2 Guías creadas

Equipo

Cal Poly, Team S2-G5, Livingston Winter 2018 Miembro de Cal Poly, Team S2-G5, Livingston Winter 2018

CPSU-LIVINGSTON-W18S2G5

4 Miembros

10 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 10

Ultimos 30 días: 48

Todo El Tiempo: 5,177