Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Are your beaters not staying in? You may need to replace the beater rings.

  1. Insert the back of a plastic opening tool into one of the beater holes Apply force to pull the circular plastic part off.
    • Insert the back of a plastic opening tool into one of the beater holes

    • Apply force to pull the circular plastic part off.

    • If necessary, use the other side of the plastic opening tool to pry the circular plastic part off.

  2. Use a Phillips #2 screwdriver to remove the two 20mm screws holding the bottom plastic piece in place. Remove the bottom plastic piece using a plastic opening tool.
    • Use a Phillips #2 screwdriver to remove the two 20mm screws holding the bottom plastic piece in place.

    • Remove the bottom plastic piece using a plastic opening tool.

  3. Using a Phillips 2 screwdriver, remove the three 20.0mm screws holding the motor assembly in place. Use your hands to remove the motor assembly.
    • Using a Phillips 2 screwdriver, remove the three 20.0mm screws holding the motor assembly in place.

    • Use your hands to remove the motor assembly.

  4. Firmly grip the motor in your hand. Using pliers, pull the connectors off the motors. Some force may be required. Be careful not to cut yourself on any electrical components.
    • Firmly grip the motor in your hand. Using pliers, pull the connectors off the motors.

    • Some force may be required. Be careful not to cut yourself on any electrical components.

  5. Lie the motor down flat on a table. Using a pair of tweezers, remove the ring from the plastic knob.
    • Lie the motor down flat on a table.

    • Using a pair of tweezers, remove the ring from the plastic knob.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Brad Daniels

Miembro Desde 10/02/16

537 Reputación

3 Guías creadas

Equipo

USF Tampa, Team 2-3, Sullivan Spring 2016 Miembro de USF Tampa, Team 2-3, Sullivan Spring 2016

USFT-SULLIVAN-S16S2G3

3 Miembros

4 Guías creadas

Anyone know of a site that sells replacement beater gears?

joescherzo - Contestar

Nice set by step process but where does one get the rings?

M Stevens - Contestar

try Sears parts.com

Yvette Tower - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 22

Ultimos 30 días: 134

Todo El Tiempo: 3,844