Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert an opening pick underneath the speaker bezel, and slide it along the perimeter to separate it from the tablet.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the six pink 3mm T3 Torx screws from the back case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Wedge opening picks around the perimeter between the display and back case.
-
Work the opening picks around the perimeter until the two halves disengage from each other.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the flat end of a spudger to pry up and disconnect the rear panel press-fit connector from the motherboard.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
There may be a glue strip between the battery and the outside case. Gently pry the case open and use the flat end of a spudger to separate the glue strip.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grab the yellow tape with a pair of tweezers and pull upwards to disconnect the press-fit connector.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the flat end of a spudger to disconnect the front camera press-fit connector from the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the nine 3mm T6 Torx screws from the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to pry up and disconnect the antenna cable from the motherboard.
-
Pull the antenna cable up and off of the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to disconnect the second antenna cable from the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the flat end of a spudger to pry up and disconnect the front camera press-fit connector from the motherboard.
-
Remove the front camera.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.
2 comentarios
This is a good tutorial but there is no mention of the bottom two connectors attached to the motherboard and some tips on reattaching these, i.e. the connector cables can be extended and then pulled back to normal to make reattachment possible
Exactly! Followed this tutorial today, wanted to replace motherboard, and almost ripped off the lcd/touch connectors and flat cables because didn’t know they are there. It’s a bit difficult to put them back, be careful.
Neb Sek -
