Saltar al contenido principal

Kindle Fire HDX 7" Ambient Light Sensor Replacement

Qué necesitas

  1. Kindle Fire HDX 7" Ambient Light Sensor Replacement, Speaker Bezel: paso 1, imagen 1 de 3 Kindle Fire HDX 7" Ambient Light Sensor Replacement, Speaker Bezel: paso 1, imagen 2 de 3 Kindle Fire HDX 7" Ambient Light Sensor Replacement, Speaker Bezel: paso 1, imagen 3 de 3
    • Insert an opening pick underneath the speaker bezel, and slide it along the perimeter to separate it from the tablet.

    • The adhesive is strong and may require an iOpener, or heat gun, to soften.

  2. Kindle Fire HDX 7" Ambient Light Sensor Replacement: paso 2, imagen 1 de 1
    • Remove the speaker bezel.

  3. Kindle Fire HDX 7" Ambient Light Sensor Replacement, Rear Panel: paso 3, imagen 1 de 1
    • Remove the six pink 3mm T3 Torx screws from the back case.

  4. Kindle Fire HDX 7" Ambient Light Sensor Replacement: paso 4, imagen 1 de 2 Kindle Fire HDX 7" Ambient Light Sensor Replacement: paso 4, imagen 2 de 2
    • Wedge opening picks around the perimeter between the display and back case.

    • Work the opening picks around the perimeter until the two halves disengage from each other.

    • Don't completely separate as the display ribbon cable still connects the two.

  5. Kindle Fire HDX 7" Ambient Light Sensor Replacement: paso 5, imagen 1 de 1
    • Use the flat end of a spudger to pry up and disconnect the rear panel press-fit connector from the motherboard.

    • There may be a glue strip between the battery and the outside case. Gently pry the case open and use the flat end of a spudger to separate the glue strip.

  6. Kindle Fire HDX 7" Ambient Light Sensor Replacement, Ambient Light Sensor: paso 7, imagen 1 de 1
    • Pry up the ambient light sensor press-fit connector from the motherboard with the flat end of a spudger.

  7. Kindle Fire HDX 7" Ambient Light Sensor Replacement: paso 8, imagen 1 de 3 Kindle Fire HDX 7" Ambient Light Sensor Replacement: paso 8, imagen 2 de 3 Kindle Fire HDX 7" Ambient Light Sensor Replacement: paso 8, imagen 3 de 3
    • The motherboard has been removed in this image, but its removal is not necessary to complete this replacement.

    • Pull the ambient light sensor out of its socket with a pair of tweezers to remove.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Blake Klein

Miembro Desde 01/29/17

70,510 Reputación

50 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 6

Todo El Tiempo: 580