Saltar al contenido principal

Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement

Qué necesitas

  1. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement, Batteries: paso 1, imagen 1 de 1
    • Turn the controller over to the backside and locate the battery cover screw.

  2. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: paso 2, imagen 1 de 1
    • The battery cover 8.0mm Phillips #2 screw is on the bottom left handle. There is a plastic washer holding the screw to the cover, so completely loosen the screw, but do not remove.

  3. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: paso 3, imagen 1 de 1
    • Once the screw is removed lift the battery cover up from the controller.

  4. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: paso 4, imagen 1 de 1
    • Remove the 2 AA batteries.

  5. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement, Internal Chip: paso 5, imagen 1 de 1
    • Remove both 6.0mm Phillips #1 screws holding the D-pads in place.

  6. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: paso 6, imagen 1 de 1
    • Insert wisdom here.

  7. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: paso 7, imagen 1 de 1
    • Remove the six 8.1 Phillips #1 screws.

  8. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: paso 8, imagen 1 de 1
    • Lift the antenna holder away from the controller towards the top of the antenna.

  9. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: paso 9, imagen 1 de 1
    • Before you separate both halves of the controller make sure the battery holder is facing you so the D-pads stay in place.

    • Separate both halves of the controller.

  10. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: paso 10, imagen 1 de 1
    • Remove the 7.9 Phillips #1 screw that holds both the antenna and the internal chip.

  11. Kid Galaxy Morphibians Explorer Controller Internal Chip Replacement: paso 11, imagen 1 de 1
    • Remove the internal chip by pulling it away from the controller.

    • Remove both the positive(red wire) and negative(black wire) from the battery terminals.

    • Reverse the steps to put everything back together.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

USF Tampa, Team 1-2, Hickman Fall 2014 Miembro de USF Tampa, Team 1-2, Hickman Fall 2014

USFT-HICKMAN-F14S1G2

3 Miembros

7 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 177