Introducción

This guide give instructions on how to locate the keypad for removal and/or repair.

Partes

No se requieren partes.

Flip over the phone and then slide down the back cover with your thumb.
  • Flip over the phone and then slide down the back cover with your thumb.

Agregar Comentario

Lever out the battery from the phone using your thumb.
  • Lever out the battery from the phone using your thumb.

Agregar Comentario

Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment. Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.
  • Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.

Agregar Comentario

Gently pull off hinge cap piece from the the top of the phone.
  • Gently pull off hinge cap piece from the the top of the phone.

Agregar Comentario

Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.
  • Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.

Agregar Comentario

Open the phone and turn it on its side. Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.
  • Open the phone and turn it on its side.

  • Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.

Agregar Comentario

Using your hand, gently pull of the back panel from the bottom half of the phone.
  • Using your hand, gently pull of the back panel from the bottom half of the phone.

Agregar Comentario

Close the phone and place it on a flat surface.
  • Close the phone and place it on a flat surface.

  • Using a plastic opening tool or your finger, lift up the motherboard from the bottom casing.

  • Be careful when pulling up the board, as there is still a ribbon cable attached to the back of the board.

Agregar Comentario

On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.
  • On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.

  • Using a plastic opening tool, slowly detach the ribbon cable connector, then pull the motherboard away from the frame.

Agregar Comentario

Once the motherboard is moved out of the way, pry out the keypad with a plastic opening tool
  • Once the motherboard is moved out of the way, pry out the keypad with a plastic opening tool

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Andrew

Miembro Desde 04/10/10

358 Reputación

8 Guías creadas

Equipo

Cal Poly, Team 4-46, Amido Fall 2010 Miembro de Cal Poly, Team 4-46, Amido Fall 2010

CPSU-AMIDO-F10S4G46

4 Miembros

14 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 3

Todo El Tiempo: 2,097