Saltar al contenido principal

Introducción

Use this guide to replace a faulty electronic control on your Kenmore 110 Washing Machine.

  1. Unplug the washing machine!
    • Unplug the washing machine!

    • Using a 5/16" socket wrench or an adjustable wrench, remove the three screws from the top rear of the washer.

    • Lifting from the rear, remove the top panel.

    • The top panel will still be connected by wires and hoses. It will help if you have a flat raised surface to set the top panel on.

  2. Using a 5/16" socket wrench or a hand wrench, remove the two screws from the component cover. From the bottom, pull out and remove the component cover. From the bottom, pull out and remove the component cover.
    • Using a 5/16" socket wrench or a hand wrench, remove the two screws from the component cover.

    • From the bottom, pull out and remove the component cover.

  3. Carefully remove the three wire harnesses. With a phillips head screwdriver, remove the three mounting screws.
    • Carefully remove the three wire harnesses.

    • With a phillips head screwdriver, remove the three mounting screws.

Conclusión

To reassemble your device, follow these instructions in reverse order.

9 personas más completaron esta guía.

Robert Trout

Miembro Desde 26/09/12

1,039 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 15-43, Forte Fall 2012 Miembro de Cal Poly, Team 15-43, Forte Fall 2012

CPSU-FORTE-F12S15G43

5 Miembros

10 Guías creadas

3 comentarios

the machine is not completing the wash cycle. stop in the rinse and spin cycle.

is there a fix for this?

R Snagg - Contestar

I am having the same problem. Did you ever find a fix?

Paul Bennett -

Did anyone find a fix for this problem?

Ron Rafe - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 5

Ultimos 7 días: 21

Ultimos 30 días: 102

Todo El Tiempo: 22,665