Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lay the JBL Pulse 3 on its side as shown in the picture.
-
Use a plastic opening tool to lift the top right corner of the speaker grill. A small amount of force is necessary to remove the grill.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Repeat step 1 for bottom right corner of speaker grill.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After pulling the right side of the grill off, place thumb underneath grill as shown in the picture.
-
Lift and pull straight out to pull grill off the posts.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Repeat steps 1-3 for the left side of the speaker grill on the JBL Pulse 3. The speaker grill should now be completely removed from the JBL Pulse 3.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a Phillips #00 screwdriver to remove the six black 6mm screws on the inside of the top of the bottom section.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the JBL Pulse 3 right-side up and unscrew the top ring of the device. A small amount of force and/or a cotton cloth may be necessary to remove this piece.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the six 5mm screws on top of the JBL Pulse 3 with a Phillips #0 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the five 7mm screws on the inside of the JBL Pulse 3 with a Phillips #1 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Peel off black, taped-on electrical lead from the inside side of the JBL Pulse 3.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the top section of the JBL Pulse 3 up. The outside casing to the JBL Pulse 3 should now be removed.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a Phillips #2 screwdriver to remove the six 11 mm screws that circle the bottom of the LED light display.
-
Pull the LED light display off of the JBL Pulse 3 base.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use tweezers to pull the five connections off of the LED light display.
-
Cancelar: No complete esta guía.
3 personas más completaron esta guía.
4 comentarios
Hello,I really need some code to show me how to initialize and LED display and how to output data from it.Any help is much appreciated.
Where to buy the leds?