Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

JBL Pulse 2 Button Circuit Board Replacement

Qué necesitas

  1. JBL Pulse 2 Button Circuit Board Replacement, Button Circuit Board: paso 1, imagen 1 de 2 JBL Pulse 2 Button Circuit Board Replacement, Button Circuit Board: paso 1, imagen 2 de 2
    • Remove the rubber rings from either end of the device.

    • If there is difficulty in lifting the rings from the device, use the metal spudger.

  2. JBL Pulse 2 Button Circuit Board Replacement: paso 2, imagen 1 de 1
    • Remove the four 4.8mm Phillips #1 screws from each end of the device with the Phillips head screwdriver.

    • Lift the end pieces off of the device.

  3. JBL Pulse 2 Button Circuit Board Replacement: paso 3, imagen 1 de 1
    • Remove the four 9.5mm Phillips #1 screws from each end of the device.

  4. JBL Pulse 2 Button Circuit Board Replacement: paso 4, imagen 1 de 2 JBL Pulse 2 Button Circuit Board Replacement: paso 4, imagen 2 de 2
    • Peel one end off and slowly draw it across the length of the device until you get to the other side.

  5. JBL Pulse 2 Button Circuit Board Replacement: paso 5, imagen 1 de 3 JBL Pulse 2 Button Circuit Board Replacement: paso 5, imagen 2 de 3 JBL Pulse 2 Button Circuit Board Replacement: paso 5, imagen 3 de 3
    • Remove the four 7.9mm Phillips #1 screws along the black centerpiece of the device between the camera and the auxiliary port.

    • Lift up the casing and circuit board but do not try and remove the ribbon wires.

  6. JBL Pulse 2 Button Circuit Board Replacement: paso 6, imagen 1 de 1
    • Remove the cover from the end that the ribbon wires are attached to. It should peel off easily.

  7. JBL Pulse 2 Button Circuit Board Replacement: paso 7, imagen 1 de 2 JBL Pulse 2 Button Circuit Board Replacement: paso 7, imagen 2 de 2
    • Unlatch the mechanism holding the ribbon wires in place then disconnect them from the motherboard.

    • To access the wires, remove some of the black glue holding them in place with the spudger.

  8. JBL Pulse 2 Button Circuit Board Replacement: paso 8, imagen 1 de 2 JBL Pulse 2 Button Circuit Board Replacement: paso 8, imagen 2 de 2
    • Slowly pull the ribbon wires out from the outside.

    • If there is too much resistance, remove more of the black glue.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

3 comentarios

where can I buy that part

Wilco Peters - Contestar

I need to buy parts

hernzum - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 1

Ultimos 30 días: 11

Todo El Tiempo: 1,078