Introducción

The JBL Charge 3 has two front speaker that can be replaced individually or together. If your speakers are blown out replace them with this guide.

  1. Turn your speaker upside down and insert the plastic opening tool vertically into the slit in the front cover.
    • Turn your speaker upside down and insert the plastic opening tool vertically into the slit in the front cover.

    • Slowly pull the plastic opening tool outward to remove the four clips holding the covering in place.

    • Repeat this process for all four edges of the front cover.

    Agregar Comentario

  2. Pull apart your cover gently from both sides and remove it from the speaker housing.
    • Pull apart your cover gently from both sides and remove it from the speaker housing.

    • The inside of the front cover has holes that must match with their corresponding pins on the speaker housing for proper reassembly.

    • Any further disassembly of your speaker will require removing waterproof seals and gaskets. Your device may no longer be waterproof after these have been altered.

    Agregar Comentario

    • Remove the eight 10mm Phillips #1 screws from around the two front speakers.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Pull gently on one of the speakers so it is outside of the housing. Be careful as it is still attached with the wires to the motherboard.

    Agregar Comentario

    • Press the small metal tab on the speaker connector with a Phillips #000 screwdriver and gently pull the connector apart.

    Agregar Comentario

    • Repeat the previous step for the second connector.

    Agregar Comentario

    • Grab the bundled cable connector that joins the speakers to the motherboard with tweezers. Gently pull the connector free.

    Agregar Comentario

    • Now that the second speaker is disconnected from the motherboard, pull the speaker and wires out of the housing.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Aidan Hays

Miembro Desde 08/10/18

272 Reputación

2 Guías creadas

Equipo

Cal Poly, Team S13-G1, White Fall 2018 Miembro de Cal Poly, Team S13-G1, White Fall 2018

CPSU-WHITE-F18S13G1

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 16

Últimos 7 Días: 107

Últimos 30 Días: 170

Todo El Tiempo: 188