Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Ion Air Pro Body Cover Replacement

Qué necesitas

  1. Ion Air Pro Body Cover Replacement, Body Cover: paso 1, imagen 1 de 1
    • Unscrew all six screws.

    • Make sure you put the screws in a good spot where you won't lose them because they are small.

  2. Ion Air Pro Body Cover Replacement: paso 2, imagen 1 de 1
    • After you're done with unscrewing, take off the blue lid shown here.

  3. Ion Air Pro Body Cover Replacement: paso 3, imagen 1 de 1
    • Next, on the other side of the device, you would lift this black piece of cover that is underneath the cap, on the bottom side of the Ion Air Pro.

  4. Ion Air Pro Body Cover Replacement: paso 4, imagen 1 de 1
    • After removing the black lid off, you have to unscrew all eight screws here.

    • Again make sure you keep track of your screws and don't lose them.

  5. Ion Air Pro Body Cover Replacement: paso 5, imagen 1 de 1
    • After unscrewing all eight screws, there are two more screws, one on each side, inside this socket that you will have to remove as well.

  6. Ion Air Pro Body Cover Replacement: paso 6, imagen 1 de 1
    • Next, you would want to unscrew the two screws located here.

  7. Ion Air Pro Body Cover Replacement: paso 7, imagen 1 de 1
    • You could then detach the bottom black piece off from the bottom side but do not disconnect it from the wires.

    • Everything inside is still connected with all the wires in there so be careful not to pull too hard or else everything inside could fall out or get broken.

  8. Ion Air Pro Body Cover Replacement: paso 8, imagen 1 de 1
    • Finally, you can remove the body cover off and replace it with a new one if you have to.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Equipo

UW Stout, Team S6-G2, Ogden Fall 2018 Miembro de UW Stout, Team S6-G2, Ogden Fall 2018

UWSTOUT-OGDEN-F18S6G2

4 Miembros

5 Guías creadas

4 comentarios

Hey Chris where can I buy a replacement body cover?

The thread of the screw socket on my ion air pro WiFi has worn out and it can no longer be screwed onto any mounts.

Sam s - Contestar

I LOST THE LOSTTHE REAR COVER WHILE HUNTING. iS THERE A REPLACEMENT I CAN GET

mcbee1010 - Contestar

i lost the rear cover cap while hunting. can i purchase a new one

mcbee1010 - Contestar

Can you show a photo of the other side (compared to step 8) showing the mounting thread please?

Andrew Mawby - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 7

Todo El Tiempo: 622