Introducción

This guide will teach the reader to install a new Battery Circuit Connector into the battery case. This may need to be done if the batteries are not delivering electricity into the camera.

Partes

No se requieren partes.

  1. Flip the camera over so the bottom is facing you. Flip the camera over so the bottom is facing you.
    • Flip the camera over so the bottom is facing you.

  2. Open the cover on the bottom by sliding it in the direction of the arrow. Open the cover on the bottom by sliding it in the direction of the arrow.
    • Open the cover on the bottom by sliding it in the direction of the arrow.

  3. ¡Envío gratuito para todos los pedidos de más de USD100.00 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda

    Ever fixed something? That’s Genius.

    Share your repair story with #ImAGenius

    Todos somos Genios

    Share your repair story with #ImAGenius

  4. Remove the batteries by pulling up on the top with your fingers.
    • Remove the batteries by pulling up on the top with your fingers.

  5. Remove the three screws from the circuit connector.
    • Remove the three screws from the circuit connector.

  6. Remove the connector from the battery holder door.
    • Remove the connector from the battery holder door.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Nick Oleskowicz

Miembro Desde 03/04/12

263 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 15-13, Forte Spring 2012 Miembro de Cal Poly, Team 15-13, Forte Spring 2012

CPSU-FORTE-S12S15G13

5 Miembros

5 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 2

Todo El Tiempo: 1,328