Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.
Introducción
The oscillation gear swivels the head of the fan back and forth by translating power from the motor into the oscillation arm.
Qué necesitas
-
-
Unplug your fan.
-
Remove the 20 mm bolt that fastens the fan ring located at the bottom of the fan cage with a Phillips #3 screwdriver.
-
-
-
Remove the 8 mm bolt fastening the fan blades to the rotor with a Phillip #3 screwdriver.
-
-
-
Unscrew the four 8 mm bolts that fasten the back of the fan cage back to the motor housing with a Phillips #3 screwdriver.
-
-
-
-
Unscrew the 10 mm screw in the center hole of the oscillation knob with a Phillips #3 screwdriver.
-
-
-
Use your fingers to gently pull the power knob directly away from the motor housing.
-
-
-
Using a Phillips #3 screwdriver, unscrew and remove the 7 mm long bolt and small washer fastening the yellow and green wire to the motor housing support.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.