Insignia NS-CLIP02 Power Auxiliary Port Replacement Replacement

Introducción

The Insignia NS-CLIP02 can develop a problem with power auxiliary ports malfunctioning, but don’t worry. They’re replaceable! If your device is not charging, this may be a key indicator that the port needs to be replaced.

Use this simple step-by-step guide to replace your motherboard that contains the auxiliary port in 30 minutes or less.

Qué necesitas

Paso 1 Power Auxiliary Port Replacement

Insignia NS-CLIP02 Power Auxiliary Port Replacement Replacement, Power Auxiliary Port Replacement: paso 1, imagen 1 de 1

Locate the bottom of the device.

Traducir

Paso 2

Peel back the adhesive sticker using a metal spudger and remove the 11mm screw beneath the sticker with a Phillips head screw driver.

Traducir

Paso 3

Using a plastic spudger, peel off the adhesive gel stoppers.

Traducir

Paso 4

Unscrew the six 11mm screws with a Phillips head screw driver.

Traducir

Paso 5

Remove the bottom of the device to reveal the motherboard.

Traducir

Paso 6

Unscrew the 9.5mm screw located near the center of the motherboard with a Phillips head screw driver.

Traducir

Paso 7

Lift the motherboard from the device and lie it face down. Beware of the cables plugged in on the back side

Traducir

Paso 8

Remove the plug to your left.

Traducir

Paso 9

Remove the plug to your right from the motherboard.

Traducir

Paso 10

Remove the plug in the front of the lcd screen plug.

Traducir

Paso 11

Remove the LCD screen plug last. For reassembly, follow the instructions in reverse order, replacing the old motherboard with the new one to fix the power auxiliary port.

Traducir