Repara tus cosas Comunidad Tienda

Insignia 6-Quart Pressure Cooker Float Valve Replacement

Introducción

Float valves may wear out over time, preventing them from rising or falling correctly. This guide will demonstrate how to replace the float valve.

  1. Insignia 6-Quart Pressure Cooker Float Valve Replacement, Float Valve: paso 1, imagen 1 de 1

    • Remove the lid and place it upside-down on a flat surface.

    Editar

  3. Insignia 6-Quart Pressure Cooker Float Valve Replacement: paso 2, imagen 1 de 1

    • Pinch the rubber gasket on the float valve and pull up.

    Editar

  4. Insignia 6-Quart Pressure Cooker Float Valve Replacement: paso 3, imagen 1 de 2 Insignia 6-Quart Pressure Cooker Float Valve Replacement: paso 3, imagen 2 de 2

    • Pull the rubber gasket off of the metal rod.

    • The valve will fall out of its hole onto the table. It can now be cleaned or replaced.

    • You may find it helpful to push up on the float valve from the other side of the lid while you remove the gasket.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Autor

con 4 otros colaboradores

Savannah Webb

Miembro Desde 01/18/18

657 Reputación

5 Guías creadas

Insignias: 7

+ 4 más insignias

Equipo

Cal Poly, Team S12-G3, Banghart Winter 2018 Miembro de Cal Poly, Team S12-G3, Banghart Winter 2018

CPSU-BANGHART-W18S12G3

4 Miembros

5 Guías creadas

2 comentarios

I received the replacement valve and pot. Now my insignia instapot won't hold pressure. It keeps seeping steam/spritz out of the float valve. I am ready to toss it in the trash. It worked bafore I replaced that stem. I should've kept it.

Carole Neider - Contestar

OK after much digging, I found the old valve and now it is pressurizing.

Carole Neider - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 4

Ultimos 7 días: 24

Ultimos 30 días: 76

Todo El Tiempo: 4,344