Introducción

This repair guide will aid you in taking apart your IBM ThinkPad T41 laptop to reach and replace its speakers.

Partes

No se requieren partes.

Close the screen and turn the closed laptop over.
  • Close the screen and turn the closed laptop over.

  • Remove all 17 screws on the bottom of the computer.

  • The multiple colors (turquoise, red, blue, orange, yellow, and purple) are for organizational purposes, indicating different screws.

  • The yellow marker at the rear denotes the UltraBay device retaining screw. This screw is optional as the UltraBay mechanism will hold the drive or battery in place anyway. The yellow marker at the front denotes the hard disk caddy retaining screw.

You need to remove the battery, hard drive, and UltraDrive before starting step 1.

cak - Contestar

Remove the extra RAM cover, by lifting where the screw was and pulling out.
  • Remove the extra RAM cover, by lifting where the screw was and pulling out.

If there's extra RAM under the cover, remove it by spreading the retaining clips.

cak - Contestar

  • Turn the laptop right side up and open the screen.

  • Lift the keyboard, using a spudger at the seam between the keyboard and trackpad.

  • Careful of the ribbon cable underneath, which may tear if the keyboard is lifted too vigorously.

Agregar Comentario

  • Unplug the keyboard’s ribbon cable, by lifting up the edges of the plug.

  • Remove the keyboard.

Agregar Comentario

  • Close the laptop and turn it over.

  • Remove the five plastic stickers covering the screws on the front edge of the case.

  • In order to reuse the stickers, remove them carefully.

Agregar Comentario

  • Unscrew the five screws that were hidden by the stickers.

Agregar Comentario

  • Turn the computer right side up and open the screen.

  • Lift the trackpad assembly by placing hands on both edges and then pull towards you till it is free of the case.

  • Be careful of the ribbon cable underneath. It may tear if the trackpad is pulled too vigorously.

Agregar Comentario

  • Unplug the trackpad’s ribbon cable by pulling on the white plastic tab.

Agregar Comentario

  • Lift the speakers out by starting with the left end and then unsnake the wires.

Agregar Comentario

  • Unplug the wires from the motherboard.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Equipo

Cal Poly, Team 7-8, Maness Spring 2010 Miembro de Cal Poly, Team 7-8, Maness Spring 2010

CPSU-MANESS-S10S7G8

4 Miembros

26 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 7

Todo El Tiempo: 11,824