Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the ThinkPad upside down with the bottom facing you.
-
Slide the latch to the right into the unlock position.
-
While holding the latch in the unlock position, lift the battery out with your other hand.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Focus on the panel at the center of the Thinkpad.
-
Unscrew the three 4mm Phillips #0 screws that bind the panel cover to the Thinkpad.
-
Lift the panel from the right edge and remove the panel.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Before removing the wireless card, identify the three wires that need to be removed.
-
The first two wires that are on the bottom right can be easily unplugged with your fingers by pulling on the white label that comes with the wire.
-
For the last wire on the center right, use a plastic opening tool to pry out the wire.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the plastic opening tool to pry the hinges on the side of the wireless card. These hinges hold the wireless card in place.
-
The wireless card will pop up at an angle, and can then be easily pulled out.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.
Equipo
Cal Poly, Team 3-20, Amido Fall 2012 Miembro de Cal Poly, Team 3-20, Amido Fall 2012
CPSU-AMIDO-F12S3G20
3 Miembros
16 Guías creadas
Un comentario
I f i take out this component will the computer act normally The computer has a car diagnostic program installed as an after thought as i wish to be normal computer Do i just remove and ever thing okay thanks Terry
