Huawei P9 Back Cover - Guía de reparación iFixit

Introducción

Use this guide to open your Huawei P9 smartphone.

Qué necesitas

Paso 1 Back Cover

Huawei P9 Back Cover, Back Cover: paso 1, imagen 1 de 3

Huawei P9 Back Cover, Back Cover: paso 1, imagen 2 de 3

Huawei P9 Back Cover, Back Cover: paso 1, imagen 3 de 3

First switch off your phone and remove the SIM card tray.
Unscrew the two Pentalobe P2 screws located at the bottom next to the device's USB C port.
If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.

Paso 2

Huawei P9 Back Cover: paso 2, imagen 1 de 2

Huawei P9 Back Cover: paso 2, imagen 2 de 2

Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.
Use an iSclack or a suction handle to separate the phone assembly from the rear panel.
In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.
Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.

Paso 3 Fingerprint sensor

Huawei P9 Back Cover, Fingerprint sensor: paso 3, imagen 1 de 2

Huawei P9 Back Cover, Fingerprint sensor: paso 3, imagen 2 de 2

Disconnect the fingerprint sensor using a spudger.

Conclusión

To reassemble your device, follow these instructions in reverse order.

7 personas más completaron esta guía.

Autor

con 6 otros colaboradores

Tobias Isakeit

Miembro Desde 03/31/14

117,504 Reputación

188 Guías creadas

+ 43 más insignias

Equipo

Master Techs Miembro de Master Techs

Community

322 Miembros

2,528 Guías creadas

0 comentarios

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 3

Ultimos 30 días: 8

Todo El Tiempo: 8,933