Repara tus cosas Comunidad Tienda

Huawei P10 Lite Rear Camera Replacement

Introducción

Use this guide to replace the rear camera in your Huawei P10 Lite smartphone. When reassembling your phone apply new adhesive where it is necessary.

Qué necesitas

  1. Huawei P10 Lite Rear Camera Replacement, Back cover: paso 1, imagen 1 de 3 Huawei P10 Lite Rear Camera Replacement, Back cover: paso 1, imagen 2 de 3 Huawei P10 Lite Rear Camera Replacement, Back cover: paso 1, imagen 3 de 3

    • Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive.

    • Using a suction handle to lift the back cover may help to get an initial gap for the opening pick to put in.

    • If the adhesive is hard to cut, use an iOpener to loosen it.

    Traducir

  2. Huawei P10 Lite Rear Camera Replacement: paso 2, imagen 1 de 3 Huawei P10 Lite Rear Camera Replacement: paso 2, imagen 2 de 3 Huawei P10 Lite Rear Camera Replacement: paso 2, imagen 3 de 3

    • After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone.

    • Flip the rear cover over to the right side of the phone.

    Traducir

  4. Huawei P10 Lite Rear Camera Replacement: paso 3, imagen 1 de 2 Huawei P10 Lite Rear Camera Replacement: paso 3, imagen 2 de 2

    • Use a pair of tweezers to remove the sticker.

    • Remove the two Phillips #00 screws.

    • Remove the four 2.5 mm Phillips #00 screws.

    Traducir

  5. Huawei P10 Lite Rear Camera Replacement: paso 4, imagen 1 de 2 Huawei P10 Lite Rear Camera Replacement: paso 4, imagen 2 de 2

    • Use tweezers to remove the mainboard shield.

    • Use the flat end of a spudger to disconnect the finger print sensor flex cable.

    • When reassembling apply new adhesive where it is necessary.

    Traducir

  6. Huawei P10 Lite Rear Camera Replacement, Battery Disconnection: paso 5, imagen 1 de 3 Huawei P10 Lite Rear Camera Replacement, Battery Disconnection: paso 5, imagen 2 de 3 Huawei P10 Lite Rear Camera Replacement, Battery Disconnection: paso 5, imagen 3 de 3

    • Remove the Phillips screw holding the battery connector plate in place.

    • Remove the battery connector plate.

    • Use the flat end of a spudger to disconnect the battery flex cable.

    Traducir

  7. Huawei P10 Lite Rear Camera Replacement, Rear Camera: paso 6, imagen 1 de 2 Huawei P10 Lite Rear Camera Replacement, Rear Camera: paso 6, imagen 2 de 2

    • Use the flat end of a spudger to disconnect the rear camera flex cable.

    • Remove the rear camera.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order. When reassembling your phone apply new adhesive where it is necessary.

Una persona más ha completado esta guía.

Autor

con 1 otro colaborador

Dominik Schnabelrauch

Miembro Desde 11/23/16

202,516 Reputación

682 Guías creadas

Insignias: 40

+ 37 más insignias

Equipo

iFixit Miembro de iFixit

Staff

135 Miembros

16,718 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 4

Todo El Tiempo: 2,124