Introducción

Use this guide to replace the charging board in your Huawei P10 Lite smartphone. When reassembling your phone apply new adhesive where it is necessary.

  1. Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive. If the adhesive is hard to cut, use an iOpener to loosen it. If the adhesive is hard to cut, use an iOpener to loosen it.
    • Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive.

    • If the adhesive is hard to cut, use an iOpener to loosen it.

  2. After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone. Flip the rear cover over to the right side of the phone. Flip the rear cover over to the right side of the phone.
    • After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone.

    • Flip the rear cover over to the right side of the phone.

  3. Use a pair of tweezers to remove the sticker. Remove the two Phillips #00 screws.
    • Use a pair of tweezers to remove the sticker.

    • Remove the two Phillips #00 screws.

    • Remove the four 2.5 mm Phillips #00 screws.

  4. Use tweezers to remove the mainboard shield. Use the flat end of a spudger to disconnect the finger print sensor flex cable.
    • Use tweezers to remove the mainboard shield.

    • Use the flat end of a spudger to disconnect the finger print sensor flex cable.

    • When reassembling apply new adhesive where it is necessary.

  5. ¡Envío gratuito para todos los pedidos de más de USD100 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda
  6. Remove the Phillips #00 screw. Remove the metal shield which covers the battery flex cable. Use the flat end of a spudger to disconnect the battery flex cable.
    • Remove the Phillips #00 screw.

    • Remove the metal shield which covers the battery flex cable.

    • Use the flat end of a spudger to disconnect the battery flex cable.

  7. Remove the seven Philipps #000 screws.
    • Remove the seven Philipps #000 screws.

  8. Insert an opening pick under the right edge of the loudspeaker unit and lever it up. Grab the loudspeaker unit and remove it. Grab the loudspeaker unit and remove it.
    • Insert an opening pick under the right edge of the loudspeaker unit and lever it up.

    • Grab the loudspeaker unit and remove it.

  9. Use an iOpener to loosen the glue under the vibration motor. Remove the vibration motor.
    • Use an iOpener to loosen the glue under the vibration motor.

    • Remove the vibration motor.

  10. Use the flat end of a spudger to disconnect the interconnect cable. Use tweezers to disconnect the antenna cable.
    • Use the flat end of a spudger to disconnect the interconnect cable.

    • Use tweezers to disconnect the antenna cable.

  11. Use an iOpener to loosen the adhesive under the charging board. Remove the charging board.
    • Use an iOpener to loosen the adhesive under the charging board.

    • Remove the charging board.

Conclusión

To reassemble your device, follow these instructions in reverse order. When reassembling your phone apply new adhesive where it is necessary.

Dominik Schnabelrauch

Miembro Desde 23/11/16

26,252 Reputación

125 Guías creadas

Equipo

iFixit Miembro de iFixit

Community

100 Miembros

7,962 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 8

Últimos 7 Días: 32

Últimos 30 Días: 184

Todo El Tiempo: 2,232