Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two screws on both sides of the receiver. Keep these and the rest of the screws in a safe place.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Slide off the case to expose the internal components of the receiver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully wipe the circuit board and its components to remove any dust.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lightly spray the input and output connectors with DeoxIT on the inside of the back panel.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.
2 comentarios
As an electronic repair technician I would never advise spraying deoxit on a circuit board or removing dust with a papertowel. May I suggest using a can of compressed air to remove any dust inside the unit and focusing the use of contact cleaner on potentiometers, input/output jacks, sockets/plugs etc. Cleaning the top of the circuit board will do little to nothing to improve the performance or sound of your amplifier as you will simply be cleaning the top side of components that are physically soldered to pads on the other side of the PCB.
A soft long bristle brush