Saltar al contenido principal

Introducción

This guide will show you how to clean the CPU fan on the VivoBook.

  1. Use a Phillips 0 screwdriver to remove nine Phillips screws from the back of the laptop (four 7mm from the top hinge, four 5mm from the bottom hinge, and one 10mm screw from the center). Use a Phillips 0 screwdriver to remove nine Phillips screws from the back of the laptop (four 7mm from the top hinge, four 5mm from the bottom hinge, and one 10mm screw from the center).
    • Use a Phillips 0 screwdriver to remove nine Phillips screws from the back of the laptop (four 7mm from the top hinge, four 5mm from the bottom hinge, and one 10mm screw from the center).

  2. Use a plastic opening tool to pry the back panel off.
    • Use a plastic opening tool to pry the back panel off.

  3. Use a Phillips 0 screwdriver to remove the eight 5mm Phillips screws holding the battery in place. Use a Phillips 0 screwdriver to remove the eight 5mm Phillips screws holding the battery in place.
    • Use a Phillips 0 screwdriver to remove the eight 5mm Phillips screws holding the battery in place.

  4. Remove the ribbon cable with a pair of tweezers. Remove the ribbon cable with a pair of tweezers.
    • Remove the ribbon cable with a pair of tweezers.

  5. Lift and remove the battery.
    • Lift and remove the battery.

  6. Gently peel off the tape from the fan.
    • Gently peel off the tape from the fan.

  7. Remove five 5mm screws using a Phillips 0 screwdriver. Remove the two 2mm screws with a Phillips 000 screwdriver.
    • Remove five 5mm screws using a Phillips 0 screwdriver.

    • Remove the two 2mm screws with a Phillips 000 screwdriver.

  8. Disconnect the fan's power cable by pulling upward on the pin connector with a pair of tweezers.
    • Disconnect the fan's power cable by pulling upward on the pin connector with a pair of tweezers.

  9. Grab the sides of the fan assembly and remove it by lifting upwards. Grab the sides of the fan assembly and remove it by lifting upwards.
    • Grab the sides of the fan assembly and remove it by lifting upwards.

  10. Remove the tape connected to the fan covering plate.
    • Remove the tape connected to the fan covering plate.

  11. Gently pull the covering plate from the covering tab.
    • Gently pull the covering plate from the covering tab.

  12. Remove the covering plate.
    • Remove the covering plate.

  13. From the back, push the fan out of the motor. Clean the fan using a damp cloth, and allow to dry.
    • From the back, push the fan out of the motor.

    • Clean the fan using a damp cloth, and allow to dry.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Bryann Tan

Miembro Desde 25/09/16

838 Reputación

6 Guías creadas

Equipo

USF Tampa, Team 16-2, Eyestone Fall 2016 Miembro de USF Tampa, Team 16-2, Eyestone Fall 2016

USFT-EYESTONE-F16S16G2

3 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 19

Todo El Tiempo: 676