Introducción

Removing the back plate will allow access to the inner circuitry of the calculator, which is necessary for other troubleshooting guides.

Place the calculator screen facing down with the back plate facing up.
  • Place the calculator screen facing down with the back plate facing up.

Agregar Comentario

With a #000 Philips screwdriver, remove the 6 x .286 inch screw drivers located at the top, middle, and bottom of the calculator.
  • With a #000 Philips screwdriver, remove the 6 x .286 inch screw drivers located at the top, middle, and bottom of the calculator.

Agregar Comentario

Locate the latch toward the bottom of the calculator.
  • Locate the latch toward the bottom of the calculator.

Agregar Comentario

Slide the latch to the right to release the keypad. At the same time, pull the keypad down.
  • Slide the latch to the right to release the keypad.

  • At the same time, pull the keypad down.

Agregar Comentario

Locate and remove the screw near the bottom of the calculator on the front side.
  • Locate and remove the screw near the bottom of the calculator on the front side.

    • The screw is behind where the keyboard normally sits.

Agregar Comentario

Now, turn the calculator over so the back plate faces up. Use the Plastic Prying Tool to carefully pry the back plate out at the bottom right corner. The prying order is arbitrary. The important part is for it to be sequential across the length of the calculator.
  • Now, turn the calculator over so the back plate faces up.

  • Use the Plastic Prying Tool to carefully pry the back plate out at the bottom right corner.

    • The prying order is arbitrary. The important part is for it to be sequential across the length of the calculator.

  • Repeat the prying step on the right side, moving along the perimeter of the calculator.

  • Repeat the prying step on the top right corner.

Agregar Comentario

Use your hands to manually separate the now loosened back plate from the calculator.
  • Use your hands to manually separate the now loosened back plate from the calculator.

Agregar Comentario

Conclusión

To reassemble your device, carefully push the back plate back onto the calculator. Then replace the screws back into the back plate.

John Baek

Miembro Desde 27/09/12

19 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 7-52, Forte Fall 2012 Miembro de Cal Poly, Team 7-52, Forte Fall 2012

CPSU-FORTE-F12S7G52

5 Miembros

11 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 5

Últimos 30 Días: 13

Todo El Tiempo: 3,328