How to Clean a YardWork LH3185A Snow Blower Carburetor

Introducción

Cleaning a snowblower’s carburetor helps to maintain its performance and prevent issues such as starting problems, fuel-related issues, and poor performance due to the buildup of debris and impurities in the fuel. Utilize this step-by-step guide as a resource to effectively maintain the carburetor for peak performance.

Make: YardWork
Model: LH3185A

Qué necesitas

Paso 1 How to Clean a YardWork LH3185A Snow Blower Carburetor

How to Clean a YardWork LH3185A Snow Blower Carburetor, How to Clean a YardWork LH3185A Snow Blower Carburetor: paso 1, imagen 1 de 3

How to Clean a YardWork LH3185A Snow Blower Carburetor, How to Clean a YardWork LH3185A Snow Blower Carburetor: paso 1, imagen 2 de 3

How to Clean a YardWork LH3185A Snow Blower Carburetor, How to Clean a YardWork LH3185A Snow Blower Carburetor: paso 1, imagen 3 de 3

Block the gas from coming out of the fuel tank using a locking plier.
Alternatively, some snowblowers come with a shut-off valve to lock off the gas line.

Editar

Paso 2

Remove the stop key by pulling outwards.

Editar

Paso 3

Remove the choke key using a flat screwdriver.

Editar

Paso 4

Remove the two support bolts from the outer shield using an 8 mm socket.

Editar

Paso 5

Remove another two support bolts from the outer shield using a Phillips head screwdriver.

Editar

Paso 6

Loosen the handlebar by turning the knob counterclockwise until there's enough room to safely remove the shield.

Editar

Paso 7

Remove the inner switch using the 8mm socket.

Editar

Paso 8

How to Clean a YardWork LH3185A Snow Blower Carburetor: paso 8, imagen 3 de 3

Remove the bolt that holds the reservoir in place using a 13mm socket or spanner.
Gas can leak when removing the jet, so have a bucket or towel in place.

Editar

Paso 9

Remove the reservoir by pulling downwards.

Editar

Paso 10

Clean the jet nozzle (all three holes) using a pin or small wire.

Editar

Paso 11

How to Clean a YardWork LH3185A Snow Blower Carburetor: paso 11, imagen 3 de 3

Clean the inside of the reservoir, the rubber, and the jet using the carburetor cleaner.
When reassembling the reservoir, it is crucial to carefully position the rubber component. Improper alignment of the rubber, combined with excessive tightening of the bolt, can result in damaging the rubber seal.

Editar