Saltar al contenido principal

Introducción

Is your Hover-1 riding slowly, dying while riding, or not going as fast? If you are facing these problems, a simple replacement of the battery could solve your issues. You will need a Phillips #1 screwdriver to remove the screws.

Partes

No se especificaron partes.

  1. Orient the hoverboard so that the pads are facing down. With the Phillips #1 screwdriver, remove all 18 of the screws on the underside of the board. Carefully remove the shell, lifting directly up.
    • Orient the hoverboard so that the pads are facing down.

    • With the Phillips #1 screwdriver, remove all 18 of the screws on the underside of the board.

    • Carefully remove the shell, lifting directly up.

  2. Remove the 4 screws around the battery on the case using the Phillips #1 screwdriver. Remove the case that houses the battery. Remove the case that houses the battery.
    • Remove the 4 screws around the battery on the case using the Phillips #1 screwdriver.

    • Remove the case that houses the battery.

  3. Pinch and pull apart the connecting black and yellow cable. Remove the battery from the hoverboard. Remove the battery from the hoverboard.
    • Pinch and pull apart the connecting black and yellow cable.

    • Remove the battery from the hoverboard.

Conclusión

To reassemble your device, follow the instructions in step 1 in reverse order.

Camron Clifton

Miembro Desde 22/10/18

331 Reputación

3 Guías creadas

Equipo

UC Davis, Team S7-G5, Lore Fall 2018 Miembro de UC Davis, Team S7-G5, Lore Fall 2018

UCD-LORE-F18S7G5

3 Miembros

3 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 4

Últimos 30 Días: 22

Todo El Tiempo: 294