Saltar al contenido principal

Hover-1 Rally Headlight Replacement

Qué necesitas

  1. Hover-1 Rally Headlight Replacement, Headlight: paso 1, imagen 1 de 2 Hover-1 Rally Headlight Replacement, Headlight: paso 1, imagen 2 de 2
    • Remove four 5 mm screws with a 5 mm hex key.

    • When reinstalling, gently tighten each screw simultaneously to apply equal pressure on both sides of the casing.

  2. Hover-1 Rally Headlight Replacement: paso 2, imagen 1 de 1
    • Apply pressure to both ends of the headlight to remove it from the scooter.

    • Be gentle. You will feel some resistance due to the glue that is used.

  3. Hover-1 Rally Headlight Replacement: paso 3, imagen 1 de 1
    • Once the headlight is loose from the scooter, disconnect the two wires using a soldering iron.

    • Use this soldering guide for tips on using a soldering iron.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Cami Lowrey

Miembro Desde 02/07/20

435 Reputación

3 Guías creadas

Equipo

Cal Poly, Team S7-G2, Regan Winter 2020 Miembro de Cal Poly, Team S7-G2, Regan Winter 2020

CPSU-REGAN-W20S7G2

6 Miembros

7 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 2

Todo El Tiempo: 401