Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.
Introducción
If your Hover-1 Nomad has major electrical issues, one of the gyroscope sensor boards may be damaged. You can follow this guide to remove and replace the two circuit boards in your Nomad. The circuit boards control the sensors, motors, lights, and speaker in the hoverboard.
Qué necesitas
-
-
Break the two warranty stickers by poking a screwdriver through them or peeling them off.
-
Remove the following twenty screws by rotating the screwdriver counterclockwise:
-
Eight 16.2mm Phillips #2 screws
-
Eight 15mm Phillips #2 screws
-
Four 19.1mm Phillips #2 screws
-
-
-
-
Cut the two zip ties around the bundle of wires with cutting pliers.
-
-
-
Disconnect the following wires connecting the circuit boards to the sensors and motors:
-
Disconnect the white connectors by pinching the tab and pulling up on the connectors.
-
Disconnect the black connectors by pulling the two sides apart.
-
Disconnect the green, yellow, and blue cables by pulling back the plastic shielding and pulling the ends apart.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
4 personas más completaron esta guía.
3 comentarios
Any idea were can i buy the motherboard for this hover.thanks
Where can I buy these