Repara tus cosas Comunidad Tienda

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Hover-1 H1 LED Headlight Replacement

Introducción

This guide explains how to replace the LED headlights on your Hover-1 H1 hoverboard.

Qué necesitas

  1. Hover-1 H1 LED Headlight Replacement, Bottom Shell: paso 1, imagen 1 de 1

    • Remove the ten 9mm machine screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.

    • Remove the twelve 9mm sheet metal screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.

    Traducir

  2. Hover-1 H1 LED Headlight Replacement: paso 2, imagen 1 de 1

    • Puncture the two black stickers by using the tip of a screwdriver.

    • Remove the two 9mm machine screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.

    Traducir

  3. Hover-1 H1 LED Headlight Replacement: paso 3, imagen 1 de 2 Hover-1 H1 LED Headlight Replacement: paso 3, imagen 2 de 2

    • Lift each side of the bottom shell by pulling up.

    • When lifting the shell, take care to not tear any cables from their connectors.

    Traducir

  5. Hover-1 H1 LED Headlight Replacement: paso 4, imagen 1 de 1

    • Unplug the battery by pulling gently on both sides of the orange connector.

    Traducir

  6. Hover-1 H1 LED Headlight Replacement, LED Headlights: paso 5, imagen 1 de 1

    • Unplug the lights from the battery by pulling gently on both sides of the black connector attached to the white wires.

    Traducir

  7. Hover-1 H1 LED Headlight Replacement: paso 6, imagen 1 de 1

    • Remove the vertical light from the shell by using your hands to pull it free from the surrounding shell.

    Traducir

  8. Hover-1 H1 LED Headlight Replacement: paso 7, imagen 1 de 1

    • Remove two 8mm screws using a Phillips #0 screwdriver to rotate the screws counterclockwise.

    • Remove the horizontal light by using your fingers to pull the light up out of the shell.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 3 otros colaboradores

Sara Passantino

Miembro Desde 10/08/18

326 Reputación

2 Guías creadas

Insignias: 8

+ 5 más insignias

Equipo

Cal Poly, Team S17-G6, White Fall 2018 Miembro de Cal Poly, Team S17-G6, White Fall 2018

CPSU-WHITE-F18S17G6

4 Miembros

7 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 5

Todo El Tiempo: 1,289