Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the ten 9mm machine screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.
-
Remove the twelve 9mm sheet metal screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Puncture the two black stickers by using the tip of a screwdriver.
-
Remove the two 9mm machine screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unplug the battery by pulling gently on both sides of the orange connector.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a utility knife, scratch off the hot glue from the connector attaching the red and black wires to the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the charging port connector from the motherboard by squeezing the connector and pulling the connector up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using an adjustable wrench, unscrew the nut that is attaching the charging port to the bottom shell.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the charging port to the left through the shell.
-