Saltar al contenido principal

Introducción

This guide will walk you through how to replace a faulty or worn-down front wheel on a Hover-1 Eagle scooter. You should replace your front wheel if your front wheel has been worn down or damaged. To determine if you need to replace your front wheel, refer to our Troubleshooting Guide.

  1. Wedge the spudger underneath the red reflective sticker and peel it back.
    • Wedge the spudger underneath the red reflective sticker and peel it back.

  2. Remove the four 2mm screws with a Phillips #2 screwdriver. Remove the four 2mm screws with a Phillips #2 screwdriver.
    • Remove the four 2mm screws with a Phillips #2 screwdriver.

  3. Remove the plastic axle cover by sliding the cover downwards.
    • Remove the plastic axle cover by sliding the cover downwards.

  4. Use pliers to remove the locknut.
    • Use pliers to remove the locknut.

  5. Slide the wheel out in a downwards motion to remove it from the fork.
    • Slide the wheel out in a downwards motion to remove it from the fork.

    How to take the cable out?

    Chri Fodor - Contestar

    same thing i wanna know

    it'sluigiplays 87 - Contestar

    But how do you install it, you removed it ok cool . Now how do you connect the wires to replacement new wheel motor

    JAY - Contestar

    It’s a teardown. You need to take the control panel and handlebar assembly off, and then unplug the motor inputs and temperature sensor from the controller. There are four hex screws near the top that you need to remove, and then there is a cluster of wires above the control module, which is a silver trapezoid-ish metal box with connectors coming out of it. The shiethed black cable coming up past the controller and battery contains the motor and temp sensor cables, unplug them. You will probably have to remove the controller and battery to get the cable out anyway.

    sad town - Contestar

Conclusión

To reassemble your device, follow these instructions in reverse order.

Andrew Gaskell

Miembro Desde 23/01/20

702 Reputación

5 Guías creadas

Equipo

Cal Poly, Team S1-G2, White Winter 2020 Miembro de Cal Poly, Team S1-G2, White Winter 2020

CPSU-WHITE-W20S1G2

4 Miembros

5 Guías creadas

5 comentarios

Good afternoon.

And how do you remove the cables?

dioguinho.so - Contestar

i would like to know the same thing

it'sluigiplays 87 - Contestar

where do i get the front wheel front i cant find where to buy a new front wheel

leon watts - Contestar

I would like to know as well how to take the cable out from harness. Do you have to remove everything from the battery and disconnect the throttle as well?

Mk Sub-zero - Contestar

Does anybody know how to fix the handlebar/front wheel alignment?

robandkim - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 4

Ultimos 7 días: 39

Ultimos 30 días: 130

Todo El Tiempo: 2,472