Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Partes y herramientas

Introducción

To fully access all parts of the Hover-1 Chrome, the entirety of the outer shell must be removed. This guide will go over how to completely remove the outer shell.

Partes

No se especificaron partes.

  1. Flip the Hover-1 Chrome upside down.
    • Flip the Hover-1 Chrome upside down.

    • Use a Phillips #2 screwdriver to remove the fourteen 14 mm screws from the bottom of the Hover-1.

    • Break the two black tape circles, and remove the two 15 mm Phillips screws underneath.

  2. Lift the shell without the speaker grille and unplug the battery.
    • Lift the shell without the speaker grille and unplug the battery.

  3. Lift the shell with the speaker grille. Unplug the speaker.
    • Lift the shell with the speaker grille.

    • Unplug the speaker.

    • Unplug the LEDs.

    • Unplug the power button

    • Unplug the charging port.

  4. Kits para Nintendo Switch

    Una solución rápida para volver al juego

    Comprar kits de Switch

    Kits para Nintendo Switch

    Una solución rápida para volver al juego

    Comprar kits de Switch
  5. Remove the twelve 14 mm Phillips #2 screws holding the top shell on.
    • Remove the twelve 14 mm Phillips #2 screws holding the top shell on.

    • The other six screws are on the side without the battery.

  6. Free the cables held atop the bracket holding the battery in place. Remove the four 14 mm Phillips #2 screws  holding the battery bracket in place. Pull the battery bracket free.
    • Free the cables held atop the bracket holding the battery in place.

    • Remove the four 14 mm Phillips #2 screws holding the battery bracket in place.

    • Pull the battery bracket free.

  7. Unplug the cords for the top LEDs.
    • Unplug the cords for the top LEDs.

    • The other side of the board is structurally symmetrical. However instead of going under the battery bracket, these cords go through a zip tie. These cables must be removed from the zip tie in order to continue.

  8. Turn the board over and pull the top panel off.
    • Turn the board over and pull the top panel off.

Linea de Meta

Dylan Prins

Miembro Desde 08/10/18

212 Reputación

1 Guía escrita

Equipo

Cal Poly, Team S4-G1, White Fall 2018 Miembro de Cal Poly, Team S4-G1, White Fall 2018

CPSU-WHITE-F18S4G1

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 5

Todo El Tiempo: 94