Hover 1 Eclipse Battery Replacement

Introducción

This guide will teach you how to replace the battery on your Hover 1 Eclipse. The battery is the power source for your Hover 1 Eclipse. Your battery will need replacing if it is malfunctioning or if it has been damaged. To replace your battery you must have basic knowledge of how to use a screwdriver. You must also be very careful with the wires that surround the battery when following these steps.

Paso 1 Battery

Hover 1 Eclipse Battery Replacement, Battery: paso 1, imagen 1 de 3

Hover 1 Eclipse Battery Replacement, Battery: paso 1, imagen 2 de 3

Hover 1 Eclipse Battery Replacement, Battery: paso 1, imagen 3 de 3

Using a Phillips #1 Screwdriver, remove the four 11mm screws that surround the edge of the plug side bottom shell piece.
Using a Phillips #1 Screwdriver, remove the four 13mm screws that surround the edge of the plug side bottom shell piece.
Remove the right side bottom shell piece.

Editar

Paso 2

Locate the black and red wires connected by an yellow header, Xt60.
This wire connects the battery to the motherboard.
Carefully tug on the two sides of the yellow header to disconnect them.

Editar

Paso 3

Hover 1 Eclipse Battery Replacement: paso 3, imagen 3 de 3

Using a Phillips #1 Screwdriver, remove the four 11mm screws that secure the black plastic keeping the battery in place.
Carefully remove the black plastic from the hoverboard.
Be mindful of the wires surrounding the battery.